Spring machine equipment and other machinery, we need to do a good job of routine maintenance and repair of the machine. Among them, the spring of the daily maintenance and maintenance of the lubrication work. The Kaichuang spring machine of Li manager reminder, daily when we carry out maintenance and lubrication of the spring machine, in order to improve the lubrication of spring machinery, and sometimes need to add some additives to the oil. In the following article, I would like to give you a brief introduction of the current spring machinery commonly used lubricating oil additives.
 
  ⑴Detergent dispersant. The detergent dispersant is used to neutralize the acidic compound produced by oxidation of the oil, to prevent further oxidation of the acidic compound, and to absorb the particles of the oxide, so as to disperse the oil in the oil. It can inhibit the generation of film, down like coke and paint have been generated from the metal surface cleaning, without fouling or deposits on the surface of the metal on the spring machine. This kind of detergent dispersant is a kind of antioxidant, corrosion resistant and antiwear additive. It is mainly used in the internal combustion engine oil, and its consumption accounts for more than 50% of the total lubricant additives.
 
  ⑵Antioxidant additive. Antioxidant additives can prevent oxidative deterioration of oil. Adding antioxidant in lubricating oil, can reduce the amount of oxygen absorbed oil, so as to make the lubricating oil and oxygen to form acid compounds was greatly reduced, to prevent oxidation, prolong the service life of the oil. Use of antioxidant lubricating oil run in low temperature, such as transformer oil, turbine oil, hydraulic oil, oil and other instruments.
 
  ⑶Tackifier. The viscosity of lubricating oil can be affected by the addition of tackifier. When the temperature increases, the viscosity of the molecules will "stretch" to prevent the viscosity of lubricating oil to reduce. When the temperature is low, the viscosity of the tackifier decreases, and the molecule begins to "huddle" into a compact mass, so the effect of viscosity is small, and the viscosity of the oil is too large at low temperature.
 
  ⑷Oiliness additive. Oil additives are used to improve the lubrication performance of the oil in the boundary friction, to maintain the minimum wear and low friction effect. These additives are polar molecules, directional adsorption on the metal friction surface, forming a solid oil film. This kind of oil is not easy to damage when it is subjected to high pressure. Oil additives generally play a role in boundary lubrication, but can not play the role of extreme pressure lubrication.
 
  ⑸Extreme pressure additive. Extreme pressure additives are polar organic compounds containing sulfur, phosphorus and chlorine, these compounds can not afford lubricating effect at room temperature, a compound film firm metal surface with computer spring machine under high pressure and high temperature. It is lower than the melting point of the metal, when the surface of the spring machine due to friction and temperature rise, the compound film melts, forming a smooth surface, can reduce friction and wear. In addition, the common additives are anti rust additives, pour point depressant, anti foam agent, anti oxygen and anti corrosion additives, etc..
 
  Therefore, we have to distinguish between the spring machine lubricating oil additives, such as the daily maintenance and maintenance of the spring machine is very helpful. These are a few commonly used spring oil additives, we can choose according to the actual situation of different additives to improve the effect of lubricating oil.The content source to Kaichuang spring machine: http://www.kcmcnc.com/en/, welcome to see, do not copy rights reserved!